Why do your iPhone show the Apple -Logo? General causes and effective solutions for boot problems | Mint

Although modern smartphones such as iPhones are extremely reliable, they can sometimes have problems. At the end of the day, these computers are of pocket -sized machines and may experience technical problems that not every user can understand. One unusual problem with iPhones is the appearance of the Apple logo in your screen in the same way you appear as your phone recharge or install an update. The phone freezes here or shows the logo again and again. Why do your iPhone flash the Apple logo repeatedly, you wonder? If you have recently installed an update or repair an old backup, you can sit on the Apple logo screen on your phone. In some cases, it will continue to pop up and disappear on its own without any problems for the user, but sometimes you have to act quickly to get your phone back. How you normally make iPhone work again if you see the Apple logo on your iPhone screen and see no change, your first step should perform a power regret. This process may vary depending on which iPhone you have. For iPhones 8 and later, you need to push the volume button quickly and release quickly and then do the same with the volume button. Then make sure to hold the side button and hold until your screen is empty and the Apple logo becomes visible. For iPhone 7 users, the process goes like this: Press and hold the volume -off button and silk buttons until the Apple -Logo appears. If you use an iPhone 6s or an earlier version of the device, press and hold the home button while pressing on the side or top button until you see the Apple logo. Once you did, the next step is tolerated. However, recovery mode does not always work for everyone. While it is rare that you are experiencing iPhone problems if your backup recovers or transfer data from another device, it can still happen. In this case, the best option is to connect your iPhone to a computer or a Mac and ensure it uses the latest iOS version. If not, it is wise to install the update. Simply insert your iPhone to your computer and then place it in recovery by following the same instructions that we just explained to activate a power recyon. When you see the recovery screen, Finder opens if you are on a Mac that runs Macos Catalina 10.15 or later. If you have a Mac with Macos Mojave 10.14 or earlier, or if you are on a Windows laptop, open iTunes. It is extremely important to make sure it is the latest version of the app. Then you should be able to see an option to update the iPhone. Click and then follow the instructions on the screen to download the update on your iPhone. Do not interrupt the update, and you will see that the iPhone works normal once it is complete. DFU mode There is another way to get your locker back back and it is called DFU mode for Devices Firmware Update (DFU). In this process, both the software and the firmware are installed and thus solve the problem. First, connect your iPhone to your computer/Mac and Open iTunes/Finder. Press and release the volume -up button, then do the same thing with the volume button. Note that it is for users of iPhone 8 or later. Then press and keep holding the side button until you see a black screen. Now hold the lace and volume tunes for 5 seconds. The next step is to abandon the side button, but to keep the volume button off until it is detected by your computer. The screen of your iPhone will continue to keep black while in DFU mode. Make sure you do not see the Apple logo as that would mean the phone went into recovery mode. You need to repeat the above steps to get back into DFU mode. Once everything is done, you will see the recovery option on your computer/Mac. Simply click on it and voila, your phone should start working again as usual. If none of these solutions work, it’s probably time to take your iPhone to the Apple store for recovery. A hardware problem can cause this problem to continue on your iPhone.